The 10 Best Resources For Repairs

The Proper Repair of an Air Conditioner Since it takes time for a technician to show up and repair your air conditioning unit, you may want to try repairing it yourself, for as long as you’re comfortable with the idea and have a little know how on fixing it, this decision should save you money, as well as discovering why your air conditioner failed to work. It’s important to know if the furnace isn’t the problem, so do the following procedure: set the thermostat of the air conditioner by lowering the temperature setting, check if the furnace fan is working, if it is then the problem is not in the furnace, but if it’s not working and you’ve done checking it twice, perhaps, it’s time to bring your air conditioner to a technician. Next is to check the external condensing unit and find out if the compressor and fan are working; otherwise, you’ll have to start the troubleshooting. Make sure that the power is off before starting to troubleshoot, and to do this: turn off the air conditioner and the furnace breakers from the main electrical panel before removing the condensing unit’s access panel and use a voltage tester to test on the wires that are into the contractor, this will help you find out of the power has been totally shut off.
The Essential Laws of Companies Explained
As soon as you have made sure that the power is off, remove the access panel screws and set them aside and remove the access panel and check if there are evidences of rodent’s nest or wires and electrical connectors that have been chewed, such that if there are signs, try to discharge the capacitor (but only do this if you know how) by removing the capacitor from the retaining bracket, then touch an insulated screwdriver between the H terminal and the C terminal and do the same between the F terminal and the C terminal, after which, on a single-mode capacitors, make a short between the two terminals.
The Essential Laws of Companies Explained
The procedures of replacing a new capacitor are: take first a photo of the wires before disconnecting anything, as a reference later on; use needle-nose pliers to pluck one wire at a time from the old capacitor; snap the wires into the corresponding tab of the new capacitor; wiggle each connector to see if it’s tight; swapped all the wires; and secure the new capacitor. Reinstall the disconnect block and access panel and turn on the circuit breaker including the furnace switch, and then set the thermostat to a lower temperature and wait for the air conditioner to start running. Expect then for the compressor to run and the condenser fan to spin, but if it doesn’t, it’s time to call the pro.

This entry was posted in Web Resources. Bookmark the permalink.